PCE Instruments DX-AS Durometer with Drag Needle 360º dial

Model # DX-AS

The PCE-DX-AS durometer is used for measuring surface hardness (shore A) of hard rubbers and soft plastics. The shore durometer is composed of a single component with a measuring head and a 360º dial.
To improve the readability of peak value, the device comes with a drag needle, that ensures the maximum reading can be captured. Once it has been measured, it can be reset to zero.
With the PCE-DX-AS (A) model of durometer, you will always obtain the most accurate value of maximum pressure and also be able to accurately reproduce this value.

The PCE-DX-AS durometer is used for measuring surface hardness (shore A) of hard rubbers and soft plastics. The shore durometer is composed of a single component with a measuring head and a 360º dial. To improve the readability of peak value, the device comes with a drag needle, that ensures the maximum reading can be captured. Once it has been measured, it can be reset to zero. With the PCE-DX-AS (A) model of durometer, you will always obtain the most accurate value of maximum pressure and also be able to accurately reproduce this value.
With drag needle
Measures in different hardness units
A 360º dial
Highly accurate
Meets with all standards
Supplied with a small carrying case

Force of pressure	0 to 12.5 N
Penetrating body	35º (according to Shore A)
Diameter of dial	57 mm / 2.2 in
Total length	110 mm / 4.3 in
Displayed range	0 … 100
Measurement range	10 … 90 (pressure diminishes below 10 and above 90)
Margin of error	± 1
Division of scale	1
Drag needle	Yes
Weight	160 g / < 1 lb