FLUKE i30 AC/DC Current Clamp (30A)

Model # i30

The i30 current clamp is based on Hall Effect technology for use in measurement of both DC and AC current.
The i30 may be used in conjunction with multimeters, recorders and other suitable recording instruments

The i30 current clamp is based on Hall Effect technology for use in measurement of both DC and AC current.
The i30 may be used in conjunction with multimeters, recorders and other suitable recording instruments

Electrical Specifications
Specified current range	30 mA to 30 A DC, 30 mA to 20 A AC rms
Usable current range	5 mA to 30 A DC, 30 mA to 20 A AC rms
Crest Factor	1.4 in
Output sensitivity	100 mV/A
Accuracy (at +25°C)	±1% of reading ±2 mA
Resolution	±1 mA
Load impedance	> 10 k Ohms and ≤ 100pF
Conductor position sensitivity	±1% relative to center reading
Frequency range	DC to 20 kHz (-0.5 dB)
Temperature coefficient	±0.01% of reading/°C
Power supply	9 V Alkaline, MN1604/PP3, 30 hours, low battery indicator
Working voltage (see Safety Standards section)	300 V AC rms or DC
General Specifications
Maximum conductor size	19 mm diameter
Output connection	4 mm safety connector
Output zero	Manual adjust via thumbwheel
Cable length	1.5 meters
Operating temperature range	0°C to +50°C
Storage temperature range (with battery removed)	-20°C to +85°C
Operating humidity	15% to 85% (non-condensing)
Weight	250 g
Safety	IEC 61010-1, Pollution Degree 2
	IEC 61010-2- 032: CAT III 300V
	Use of the probe on uninsulated conductors is limited to 300 V ac rms or dc andfrequencies below 1 kHz.
EMC Compatibility	IEC 61326-1: Portable Electromagnetic Environment